Install Manual
Table Of Contents
- Preface
- PLEASE READ THESE SAFETY PRECAUTIONS!
- Table of Contents
- List of Figures
- List of Tables
- AB-Access Product Overview
- Getting Started
- Base Station Installation
- Access Point Installation
- AB-Extender Installation
- Subscriber Unit Installation
- Indoor Junction Box
- Glossary
- Acronyms/Abbreviations
Axxcelera Broadband Product Install Manual Page 23 of 71
A Base Station can have up to six Access Points. Each AP consists of an outdoor transceiver
(which contains the antenna and associated electronics that transmit and receive broadband
wireless signals to and from Subscriber Units) and an indoor wallbox or access panel.
3.3 AB-Extender Units
A Base Station may have a number of AB-Extender units. Each EX consists of an outdoor
transceiver and an indoor wallbox or access panel.
3.4 A Note On Cabling
Attention! Most of the cabling used in the AB-Access System is CAT5. You will need to be
aware of the following limits on CAT5 cable lengths:
• The interconnect cable from the indoor junction box to an outdoor transceiver
must be less than 60 meters. This is due to DC resistance loss over the distance
of the cable run.
• The combined length of ATM or Ethernet interconnect cable (from the radio to
the switch) must be less than 100 meters.