User's Manual
Table Of Contents
- Revision History
- PLEASE READ THESE SAFETY PRECAUTIONS!
- Document Overview
- AB-Access Overview
- AB-Access Reference Model
- Static Configurations
- CLIP_T
- CLIP_S
- Hybrid CLIP_S
- 1483_T
- 1483_S
- Native ATM
- Extender
- RF Design and Planning
- SNMP
- Rupee
- RTFD (Return To Factory Default)
U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
9 1483_T
The 1483_T configuration is where both the AP and the SU act as a layer 2 bridge. It is
important to understand that in this configuration data can only go from SU-AP & AP-SU within
the sector. Data will not be able to from SU-SU within the same sector. This can only be done
by connecting a router to the AP and redirecting that traffic back to the AP.
9.1 Interactive 1483_T
All assumptions for troubleshooting 1483_T are based on the following diagram.
RL
BL
SL
E
RL
BL
SL
E
Ethernet HUB
Control Server
Router
192.168.3.1
MID 0
LAN
Data
192.168.3.34
192.168.3.10
192.168.3.9
Mgmt/
9.1.1 Adding AP or SU to EMS
Dialogue boxes showing the information needed to add an AP or SU are shown below.
March 10, 2003 Company Confidential Page 82 of 149