User manual

First by selecting the Array then places a check inside the check box to use the function.

After the desired command has been selected click on the submit bottom located on the

lower right to start.

Init R5/R3 Used when configuring a disk group for RAID Level 5. During an

initial RAID 5 configuration, this is automatically executed.

R5/R3 Check Used to verify the RAID 5 configuration. This option should be

executed when initially configuring for RAID 5.

Beeper Used to turn on or off the audible alarm when an error occurs or

during an Init RAID 5, R5 Check.

Stop Modem Used to stop a Page or FAX notification from being sent. Use to stop

receiving the same Page or FAX notification after the initial one has

been acknowledged.

Expand Array Used this option to increase the disk numbers to an existing

configuration. This feature can increase the array’s capacity without

backup and restore the data.

RAID SYSTEM CONFIGURATION

6.9 Terminal Port Settings

This option can be used to configure serial port settings.

The default values are as follow:

Baud Rate: 115200

Data Bit: 8 Bits

Parity: No parity Stop

Bit: 1 Stop bit

Flow Control: None

6.10 Security Settings

This function is used to change and modify the current administrator password for the

Raid subsystem.

6.11 RAID System Configuration

For its functions and descriptions please refer to page 31 under “RAID System Setup”.