User manual

5.5 Terminal Connection

Network port can be configured by telnet function. To obtain a terminal connection

please precedes the following steps.

1. Open a command prompt.

2. Type in the following command line.

telnet 1.1.1.125 9999

IP Address of the network port. Port number

There are seven options to choose from, once the connection is made.

1. Factory’s default value.

This function is used to load all the factory default for the network port.

2. TCPIP’s configuration.

This function is used to configure the TCPIP settings for the network port.

3. Channel’s configuration.

Using this function can change the serial configuration settings.

Defaults are as follows

Baudrate <115200>

Parity bits <None>

Stop bit <1>

Flow Control Settings: <1. No flow control>

4. DNS & Monitor Delta configuration