User manual

4.10 NVRAM Setup

4.10.1 General Setting

NVRAM Update

To save the configuration

NVRAM Erase

Reset the NVRAM to factory default

NVRAM Restart

Restart the NVRAM (Controller)

When using this menu option, The RAID subsystem should be off-line.

NOTE: Any changes made in this group will cause data on the drives to be permanently

Once a configuration change has been made, the NVRAM (where the settings are stored)

must be updated. If a change causes an error or if the subsystem fails, use the Erase

NVRAM option to clear the contents of NVRAM restoring the default values. In order

for a change to take effect, the RAID subsystem must be restarted. Use the Restart

option to automatically reset the RAID subsystem.

4.10.2 Update Firmware (only available 8990 controller)

This function is used to update the Raid subsystem’s firmware. This function is only

available for RaidCare server installed on Windows based system.