User manual

4.6 FC Configuration Setup

4.6.1 General Setup

Primary Fiber Submenu for configuring primary fiber settings

Hard Loop Enable hard loop ID if you wish to enter the ID manually.

Disable to have the ID set by the controller (Default: Disable)

ID Setup Enter the hard loop Id for this controller (only hard loop ID is

enabled) Connection Mode Arbitration Loop or Point-to-Point

(default: Arbitration Loop).

Data Rate 1 Giga-bits, 2 Giga-bits (Default: Auto-negotiated).

4.6.2 Lun Map

Lun Map is used to setup each Slice to map a logical Lun Number.