User manual

Steps to setup Array.

Step 1. In the RAID Array pull down menu, choose which array you wish to configure.

Step 2. After array number is selected, Check Re-Config RAID check box to begin the

configuring RAID system.

Step 3. After Re-Config RAID is checked, the pull down menu next to RAID level

should be available.

Step 4. After RAID level is selected, the pull down menu next to Disk Number in RAID

should be available. This is where a user chooses how many hard drives they

wish to use in the array. A spare should always be considered for backup in

case of HD failure.

Step 5. Click on Submit, located on the lower right of the screen.

4.5.2 General Setting

RAID subsystem setup