Service manual

SERVICE MANUAL TNC 415B/425
Page 72
Issue: 20.08.95
11.2.7 Machine Operating Panel of TE 410
The PLC inputs of the machine operating panel of TE 410 (I128 - I148) can be tested at the flange socket X3
(37-pin) on the keyboard unit TE 410 or at the flange socket X46 (connection of machine control panel) of the
TNC 415B/425.
For this purpose the TABLE function (see section 19.4) in the PLC mode is helpful as well.
KEY
of version
Flange socket X3 on
KEYBOARD UNIT PLC
KEY
of version
Flange socket X3 on
KEYBOARD UNIT PLC
01/03 02/04 PIN PIN Input 05/06
1)
PIN PIN Input
IV+ IV+
12 36.37 I139
O O
3 36.37 I130
Z´- Y´-
8 36.37 I135
I I
15 36.37 I142
Y+ Z+
10 36.37 I117
T T
21 36.37 I148
V+ V+
19 36.37 I146 1 36.37 I128
X´+ X´-
11 36.37 I138 2 36.37 I129
14 36.37 I141
NC
0
NC
0
4 36.37 I131
X´- X´+
6 36.37 I133
NC
I
NC
I
5 36.37 I132
Y- Z-
7 36.37 I134
Z´+ Y´+
9 36.37 I136
1)
remaining versions
IV- IV-
13 36.37 I140 pin 36/37 = + 24V_PLC
V- V-
20 36.37 I147