Service manual

Function MP
No. Bit A B C
Input AE-6
Entry value
Initializing parameters for
handwheel
Assignment of 3. handwheel via axis
selector switch (MP 7640 = 5)
7645.0
0
1
2-7

+ 0 = position 1 (left stop) → Z axis
position 2 → IV. axis
position 3 → V. axis
+ 1 = position 1 → X axis
position 2 → Y axis
position 3 → V. axis
position 4 → IV. axis
position 5 → V. axis
+ 2 = position 3 → Z axis
position 4 → IV. axis
position 5 → V. axis
reserved
0
Evaluation of the keys and LEDs
on HR 332 (MP 7640 = 4)
HR 410 in HR 332 mode (MP 7640 = 4)
7645.0

HR 332
0 = keys X, Y, Z, IV and their LEDs evaluated by NC
remaining keys: PLC I 164 to 170
remaining LEDs: PLC O 100 to O 106
1 = keys: PLC I 160 to I 171
LEDs: PLC O 96 to O 107
HR 410
0 = keys X, Y, Z, IV and their LEDs evaluated by NC
remaining keys: PLC I 164 to 171
remaining LEDs: PLC O 100 to O 107
1 = keys: PLC I 160 to I 171
LEDs: PLC O 96 to O 107
0
HR 410 inn HR 410 mode (MP 7640 = 6) -

0 = keys X, Y, Z, IV, actl. value transfer and their
LEDs evaluated by NC
remaining keys: PLC I 168 to 175
remaining LEDs: PLC O 100 to O 111
1 = keys: PLC I 160 to I 175
LEDs: PLC O 96 to O 111
0
R H
1.0 TNC
415B/425
Machine Parameters MP 7645.0 08.05.95 5.2 71