Service manual

Machining and Program Run
Function MP
No. Bit
A B C Input AE-6
Entry value
"Scaling factor" cycle in two or
three axes
7410*

0 = 3 axes
1 = only in the machining plane
0
Tool data in TOUCH PROBE cycle 7411*

0 = the current tool data are overwritten with the
calibrated data of the touch probe
1 = the calibrated tool data are retained
0
Cycles for milling pockets with
free-programmed contour 7420* 0 to 31
%00000
•Slot milling direction
0

0 = anti-clockwise slot milling of the pocket contours,
clockwise for islands
1 = clockwise slot milling of the pocket contours,
anti-clockwise for islands
•Sequence for clearing out and slot milling
1

0 = first slot milling, then clear out pocket
2 = first clear out pocket, then slot milling
•Merge programmed contours
2

0 = contours merged only if the tool center paths
intersect
4 = contours merged if the programmed contours
overlap
•Clear out and slot milling to pocket depth
for each peck
3

0 = clearing out and slot milling performed in one
operation for all pecks
8 = for each peck, first perform slot milling and
then feed clearing out (depending on bit 1)
before next peck
•Position after finishing a contour pocket
(cycles 6, 15, 16, 21, 22, 23, 24)
4 - 05 0 = the control moves to the position at which it was
before the cycle call
16 = only the tool axis is lifted to clearance height
after the cycle
* accessible via code number 123
R H
1.0 TNC
415B/425
Machine Parameters MP 7420 03.06.96 5.2 63