Service manual

Code Numbers

123 MACHINE PARAMETER EDITING FOR END USERS (marked by *)

75368 OFFSET ADJUSTMENT

79513 VOLTAGE AND TEMPERATURE DISPLAY

86357 REMOVE EDIT/ERASE PROTECTION

95148 MP MODE

105296 COMPENSATION VALUE LIST

531210 RESET M 1000 TO M 2000 AND BYTES 0 - 127

620159 DOWNLOAD RUN-IN PROGRAM VIA INTERFACE

807667 PLC MODE

688379 INTERNAL OSCILLOSCOPE

951026 START RUN-IN PROGRAM FROM EPROM

Machine Parameters

In the following list the machine parameters for all software versions are listed.

Since however, certain machine parameters are only valid for a certain software version, or are only active from a certain software version on,

columns with symbols for differentiation have been introduced after the machine parameter number.

Explanation of the Symbols:

 = The machine parameter applies for all software versions of this control.

04 = The machine parameter has been introduced with a certain software version (e.g. 04 means: introduced with software version 04).

I04 = The machine parameter is inactive.

- = The machine parameter is not available with this control.

Explanation of the Columns:

A = TNC 415B/F/BR/FR and TNC 425/E with NC software 259 93* -- or 259 94*

B = TNC 415B/F/BR/FR and TNC 425/E with NC software 280 54* -- or 280 56* -- (special software)

C = reserved

AE6 = entry values for operation with HEIDENHAIN test unit

1.0 TNC

415B/425

Machine Parameters Overview 18.03.96 5.1 1