Owner`s manual

– 6 –

MOUNTING & CONNECTIONS

Add a main fuse holder with appropriate fuse volume to the (+) power cable

in a distance of not more than 30 cm from the positive battery pole.

n Note that the amp-module generates heat, so a well ventilated mounting place

is necessary or it will easily overheat.

n Keepthewireconnectionsasshortaspossible,withsufcientlength,inorderto

minimize power losses and provide a higher audio output of the system.

n To minimize damage to the cables, take care that they do not pass through sharp

edged metal. Use rubber grommets were required.

n Lay all cables as far away as possible from the ignition cables, modules in the boot

and under the dashboard, as these create interference.

n Keep the length of the power cable as short as possible.

n The power cable should have at least a cable cross section of 10mm

(8 Gauge

AWG). Smaller cross sections are reducing the output power, are causing

distortions and may be triggering the overheat protection of the amp-module.