Installation guide

– 6 –

– 7 –





n Note that the amplier generates heat, so a well ventilated mounting place

is necessary or it will easily overheat.

n Keep the wire connections as short as possible, with sufcient length, in order to

minimize power losses and provide a higher audio output of the system.

n For safety reasons route all power and speaker wiring by using the existing

wire channels.

n To minimize damage to the cables, take care that they do not pass through sharp

edged metal. Use rubber grommets were required.

n Lay all cables as far away as possible from the ignition cables, modules in the boot

and under the dashboard, as these create interference.

n 



n Keep the length of the power cable as short as possible.

n The power cable should have at least a cable cross section of 10mm

(8 Gauge

AWG). Smaller cross sections are reducing the output power, are causing

distortions and may be triggering the overheat protection of the amplier.

1. Position the mounting brackets.

2. Use the tapping screws to x them.