Operation Manual

– 12 –
– 13 –
X-OVER ADJUSTMENTS
The AXTON SX component set crossovers come with an adjustment option that allow
you to tailor the sound by setting slide a switch on the pc board, to compensate for
different mounting locations of the speaker units.
The -3dB position is usually the setting that provides a good tonal balance for most in-
stalls, while the 0dB position leaves you with a slight excess of energy in the treble region.
TESTING THE INSTALLED SYSTEM
Slowly turn up the volume of your head unit, and listen for distorted sounds. If everything
appears to be okay and it just sounds right, check out the speaker balance of the left and
right side by adjusting the balance control of your headunit. Shifting the balance to the left
channel should provide you with sounds coming solely from the left speaker system, while
shifting the balance to the right should do the same for the right speakers. If anything
appears to be wrong, you must recheck the wiring of the x-overs, the amp or the mid/
woofers.
I
O
0dB
-3dB
Input terminal
Cable mid/woofer
with fast-on connector
Switch for tweeter
level -3dB/0dB
Cable tweeter
with fast-on connector