Installation Sheet

8
English
Seal the wall around the plaster
shield with waterproof sealant .
Failure to seal the wall can lead to
possible water damage.
Remove the flush insert screw using a 5 mm Allen
wrench .
Remove the flush insert and seals.
Insert the function block.
Tighten the function block screws.
Installation
Close the stops using a 4 mm Allen
wrench.
Cut the plaster shield so that it extends ¹⁄₁₆" - ⅛" from
the finished wall surface.
5
1
2
4
4 mm
3
2
1
5 mm
1
4 mm