Installation Guide

6
Trim Kit Installation
Install the valves: Starck and Citterio only
Remove the valve mounting nuts from the valves.
Push the valves up into the holes. Install the mounting
plates on the holes.
Tighten the tensioning screws.
Install the valves: all other styles
Remove the plaster shields, mounting plates, and stop
rings from the valves.
Push the valve up through the hole. Slide the stop ring
onto the valve. Install the mounting plate. The stop
ring will stop it at the proper height.
Rest the mounting plate on the mounting surface. Tight-
en the mounting nut firmly against the underside of the
mounting surface. Tighten the tensioning screws.
All models:
Connect the connecting hoses to the valve outlets.
Hold the hose steady with one wrench while tighten-
ing the hose nut with a second wrench.
Install the hot and cold supply lines (not included) on
the valve inlets.