Installation Guide

4
Install the pop-up guide assembly
Remove the nut, metal washer, and sealing washer
from the pop-up guide assembly.
Position the pop-up guide and sealing washer on the
proper hole on the bidet.
Install the metal washer and nut.
Install the pop-up drain
Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
Unscrew the tailpiece from the tee. Wrap the threads
with Teflon tape and replace.
Install the white, flexible sealing gasket on the flange.
Sith it in the sink outlet.
From below, install the black mack gasket, friction
ring, and retainer nut to the flange. Do not fully
tighten the nut at this time.
Thread the tee and tailpiece on the flange. The pivot
must face the faucet. Turn the drain assembly if neces-
sary.
Tighten the retainer nut.
Place the plunger assembly in the drain.
Install the horizontal rod so that the end goes through
the loop in the bottom of the height adjuster.
Install and tighten the pivot ball nut.
plunger
height adjuster
flange
sealing gasket
mack gasket
friction ring
retainer nut
pivot ball nut
tee
tailpiece
horizontal rod
swivel connector
vertical rod