Installation Guide

3
Rough-in Installation Instructions
Install the transfer valve
Install the y-connector and seal on the bottom of the
transfer valve. Screw the connecting hoses to the
y-connector.
Screw the elbow connector to the outlet port on the
side of the transfer valve. The arrow on the elbow
connector indicates the direction of the water flow. It
should point downward. Screw the spray hose to the
elbow connector.
Push the transfer valve, nylon washer, and one of
the china seals (tapered side up) through the transfer
valve hole in the bidet.
Install the second china seal, tapered side down.
Thread the valve mounting nut to the top of the trans-
fer valve as far as it will go. The valve mounting nut
should rest on the mounting surface.
Make sure that the transfer valve stands straight.
Install the spray assembly
Position the spray and sealing washer in the hole in
the bidet.
Install the washer and mounting nut.
Connect the spray hose to the spray, being careful not
to twist or kink the hose.