Installation Sheet

2
English
Technical Information
Water pressure
Recommended 15 - 75 PSI (0.1 - 0.5 MPa)
Maximum 145 PSI (1 MPa)
Hot water temp.
Recommended 120°-140° F (48° - 60° C)*
Maximum 158°F (70° C)*
Flow rate - 12018001
handshower max. 1.75 GPM (6.6 L/min)
spout @ 44 PSI 5.3 GPM (20 L/min)
Flow rate - 12016001
handshower max. 2.0 GPM (7.6 L/min)
spout @ 44 PSI 5.3 GPM (20 L/min)
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• This trim is for use with rough 10452181 (not
included). The rough must be installed and the
finished floor surface completed and made
watertight.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum output
temperature can be no higher than 112°F.
• 12018001 only: The handshower is for use with
an automatically compensating valve rated at
1.3 GPM (4.9 L/min) or less.
• 12016001 only: The handshower is for use with
an automatically compensating valve rated at
1.5 GPM (5.7 L/min) or less.
• The thermostatic mixing valve is for use with a
handshower rated at 1.7 GPM (6.4 L/min) or
higher.
• Protection against backflow is provided by check
valves.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.