Installation Instructions / Warranty Starck X 10070001 10071001 10205001 Starck X 10080001 10084001
Starck X Single Control Lavatory Mixer 10070001, 10071001, 10080001, 10084XX1 Starck X Bidet Mixer 10205001 10205001 10070001 10071001 10080001 Technical Data Recommended hole size Maximum depth of mounting surface Flow rate @ 45 psi Maximum water pressure Recommended water pressure: Recommended hot water temp.: 10084001 1 3/8“ 1 3/8“ 2.2 gpm 145 psi 14.5 - 75 psi 120oF - 140oF* The supply hoses require supply stops with 3/8“ compression fittings (not included).
Install the faucet: Place the faucet and sealing ring on top of the mounting surface. From beneath the mounting surface, install the friction washer, metal washer and mounting nut. Tighten the mounting nut. Tighten the tensioning screws. sealing ring friction washer metal washer mounting nut tensioning screws Connect the hoses to the supply stops with 3/8” compression fittings (not included). Place the compression nut and ferrule over the shank of the supply hose. Push the shank into the supply stop.
Change the Spray former (optional) The spray former installed at the factory produces a waterfall flow. Should the user prefer a round flow pattern, remove the waterfall spray former and replace it with the enclosed spray former 98610000. Use a 2 mm Allen wrench to remove the screws. Remove the waterfall spray former. Install spray former 98610000. Tighten the screws with the 2 mm Allen wrench.
Install the pop-up drain (10700001, 10205001 only) Remove the plunger assembly. plunger assembly Unscrew the drain outlet flange from the tee. height adjuster Unscrew the tailpiece from the tee. Wrap the threads with TeflonTM thread tape and replace. outlet flange Install the white, flexible sealing gasket to the flange. Place it in the sink outlet. From under the sink, install the black mack gasket, white friction ring , and retainer nut to the flange.
User Instructions: Pull the handle forward to turn the water off. Push it toward the rear to turn the water on. Push the handle to the right for cooler water, to the left for warmer water. The angle of the water flow may be adjusted by pivoting the spray former forward or backward. Should the flow of water diminish, remove the spray former and clean the aerator. Replacement Parts 1 2,3 4 5 9 7 6 8 1 2 3 4 5 6 7 8 9 spout spray former cpl. spray former cpl. for bidet handle nut cartridge cpl.
Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty. Cleaning Materials for Faucets and Showers • • • • To remove lime scale, use only products made specifically for that purpose.
negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner contrary to the product instructions. C. Labor or other expenses for the disconnection or return of the product for warranty service, or for installation or reinstallation of the product. D. Accessories or related products not manufactured by Hansgrohe.
