User's Manual

Axon Fleet 2 Wireless Microphone Installation and User Manual
Axon Enterprise, Inc. Page 21 of 23
Troubleshooting and Other Information
Troubleshooting
Any error states encountered with the wireless microphone and/or junction box can typically be cleared
by rebooting the devices.
• To reboot the wireless microphone - move the power switch in the off position, wait 12-15
seconds, and then move the power switch to the on position.
• To reboot the junction box - remove power from the junction box by disconnecting the
connector running from the power unit to the junction box for a few seconds and then reconnect
the connector.
Important: This action also reboots the Front Camera.
Technical Support
Visit www.axon.com and view the Support options or call 1-800-978-2737.
Warranty Policy
Axon Enterprise warranty provisions are applicable on all Axon Fleet system products. See Axon
Enterprise’s website, www.axon.com, for detailed warranty information.
Warnings
For a full list of the warning associated with this product, see www.axon.com.
Radio Waves
An Axon Fleet 2 system transmission is in the frequency ranges of 2404 – 2476 MHz.
Changes or modifications to the equipment not expressly approved by the manufacturer could void the
product warranty and the user’s authority to operate the equipment.
Your wireless device is a radio transmitter and receiver. It is designed and manufactured not to exceed
the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications
Commission (FCC) of the U.S. Government. These limits are part of comprehensive guidelines and
establish permitted levels of RF energy for the general population. The guidelines are based on standards
that were developed by independent scientific organizations through periodic and thorough evaluation of