User's Manual

Axon Fleet 2 Camera System User Manual
Axon Enterprise, Inc. Page 19 of 24
Rear Camera Controller Ring LED
The Ring LED blinks red and yellow to indicate the rear camera controller is receiving a
firmware update.
Uploading Video from the Axon Fleet 2 System
The Axon Fleet system can support the multiple offload options listed below:
Wireless via LTE
The Axon Fleet system can upload video via Long Term Evolution (LTE), a fast-wireless service,
if the vehicle has an in-car router that supports LTE. For more information, see the Axon View
XL Manual.
Wireless at Station
An agency can equip its parking facilities with wireless access points so that vehicles
equipped with Axon Fleet systems can upload their videos. For more information, see the
Axon View XL Manual.
Note: There might be additional system requirements associated with Wi-Fi offload.
USB Cable using Evidence Sync
If Evidence Sync software is installed on your computer, you can download information from
an Axon Fleet 2 camera to your computer and then upload it to the Axon Evidence website.
In order to use Evidence Sync with your Axon Fleet 2 cameras, you must separately order 2.5mm
to USB cable and USB C to USB A cable from Axon.
• The 2.5mm to USB cable is used to connect the front camera dataport to the USB port of a
computer with Evidence Sync.
• The USB-C to USB cable is used to connect the rear camera to the USB port of a computer
with Evidence Sync. The rear camera cable must be disconnected from the rear camera to
connect it to a computer using the USB-C to USB cable. The rear camera cable is retained by
2 T6 screws which must be removed to disconnect the cable.