User manual

228
Fig. 11.9.1 shows these capabilities. WinLTP was started using the default.pro protocol. Then the Log
shows AvgLoop.pro protocol file loaded. After the MainProtocol was run, the 0622A010.XLS AmpFile
was saved, and the AnalysisGraphs and Spreadsheet were cleared. Finally the AvgLoop.pro protocol file
was saved, and the WinLTP program exited.
TimeOfDay AnalysisTm Event
17:23:54.3 "" Start WinLTP
"" "" Using default.pro
"" "" Saving to 06220001.log
17:24:48.3 "" Loaded AvgLoop.pro
""
17:25:10.9 0.0 Start MainProtocol
17:25:11.4 0.5 Enter Loop0
17:25:11.4 0.5 06220314.P0, First Loop/AvgLoop sweep
17:25:26.4 15.5 06220317.AP0
17:25:46.4 35.5 06220321.AP0
17:26:06.4 55.5 06220325.AP0
17:26:11.4 1:00.5 Leave AvgLoop1
17:26:11.4 1:00.5 Leave Loop0
17:26:11.4 1:00.5 Stop MainProtocol
17:26:25.0 "" Saved 0622A010.XLS
17:26:25.1 "" Cleared AnalysisGraphs and Spreadsheet
17:26:45.6 "" Saved AvgLoop.pro
17:26:50.3 "" Exit WinLTP
Fig. 11.9.1. An Experimental Log showing loading of a protocol file, saving an AmpFile, clearing the
AnalysisGraphs and Spreadsheet, and saving a protocol file.