Operation Manual

Axnes AS
Document number
Revision
Date
AX-PNG-UMAN-1220
Issue C
2018-Jun-05
Page 2-17
Confidential document and information
Software Version: Select what to show with the configuration up and down buttons. The
following information can be displayed:
• Main SW version
• Crypto Key Name
• Battery Gauge parameter version
• CRC of the configuration (can be used to identify the configuration)
• Capabilities programmed
• Programmed serial number (Shall match S/N on the Label)
• Boot SW version
• SW hash of main SW.
Parameter Reset: Reset the parameters that can be modified from the Menu back to factory
default values. (Squelch, Audio Feedback, Headset type, VOX max. level, VOX min. level,
Display intensity). To reset the parameters:
• Enter the Parameter Reset menu
• Change from Return to Confirm with the configuration up or down arrow
• Push OK
AIS Test Mode: This menu can be used to send one burst of AIS-SART test messages from
the MP50.
Audio feedback
The MP50 implements audio feedback on events that are of importance to the operator. The
following spoken feedbacks are given:
Connected – Connection established to PNG Base Station
Connection lost – Connection to PNG Base Station lost
Locked – Key lock enabled
Unlock – Key lock unlocked
Direct – Direct mode selected
Intercom – Intercom mode selected
Local – Entering Local mode
VOX – Entering VOX mode
PTT – Entering PTT mode
Charging – Attached to battery charger
Battery low – Low battery status