Operating instructions

Assembly
8
Setting up
NOTE: Before using your disc sander you need to check that the table
is perpendicular by using a 90˚ square.
Place a 90˚ square on the sanding disc table, see fig
03 and check that the table is perpendicular to the
sanding disc. If it requires adjustment loosen the tilt
mechanism clamp (a), see fig 04 and turn the rise
and full control knob (b) until the table is at 90˚ to
the sanding disc then tighten clamp (a). DO NOT
OVERTIGHTEN
Step 7
Step 8
Step 9
Lower the disc sander on top of the stand and line up
the holes, using the four bolt (A) washer (B) and Nuts
(C) secure the sander to the stand
A
E
B
B
C
C
6
Fig 03
Table Stops
There are two adjusting nuts to the base of each
table leg, see fig 05. This is to set the gap between
the table and disc. Release the table clamps (c), using
a spanner loosen the nuts (d) and adjust the grub
Step 10