Instruction manual

MILL TABLE ASSEMBLY

The Mill/Drill includes a milling table as an accessory. To install the milling table the compound

slide must be removed from the cross slide from the lathe bed. Once installed, the milling table can

move back and forth with the cross slide. Follow the instruction below to install table.

1) Using a 12mm spanner remove the two

bolts that secure the compound slide to

the cross slide, remove the compound slide

and place safely aside. (See fig A)

3) Locate the milling table and the

supplied caphead bolts. Lower the

table onto the cross slide, line up the

holes and insert and secure the table

using a 6mm allen key. (See fig C)

2) Using a Phillips screwdriver remove the four grub screws

from the cross slide and place safely aside. (See fig B)

Fig A

Fig B

Fig C

Remove the two bolts using a 12mm spanner, remove

the compound slide from the cross slide.

Phillips screwdriver

Caphead bolt

Milling table