Instruction manual

A
B
C
D
Tip the lathe forward and have your assistant
thread the support leg up into the angle support
casting. Adjust the support leg until it makes
contact with the surface of your bench or stand,
tighten the lock nut to lock the leg in position.
Locate the tilt housing casting and three M8x30
caphead bolts and washers. Offer up the pre-drilled
holes with the holes in the support casting and
secure in place using the M8 bolts and washers.
Lift the mill assembly and slide it over the tilt
housing shaft until it is flush against the tilt
housing. Locate the 36mm nut and spanner and
lock the mill assembly in position.
DO NOT OVER TIGHTEN
Insert the Mill’s power plug into the socket
in the rear of the lathe as shown.
INITIAL ASSEMBLY - FITTING THE MILL
B
C
D
Step 3
Step 4
Step 5
Step 6
WARNING
HEAVY
TWO MAN
ASSEMBLY
!
Make sure that everything is secure then replace the splash guard as described on pages 34-35.
36
Mill power plug
Leg lock nut
Lathe socket