Instruction manual

Step 1
Step 2
A
A
B
B
C
D
INITIAL ASSEMBLY - REMOVING THE SPLASH GUARD
INITIAL ASSEMBLY - MOUNTING THE MILL
3) Loosen the two bolts and washers which clamps the opposite
end of the splash guard to the side of the lathe bed, below the tailstock.
(See fig 5)
4) Remove the splash guard and place safely aside.
Fig 5
WARNING
!
When mounting the Mill to the Lathe, we strongly advise you get
the assistance of another person because of the weight of the
machine.
Remove the four grub screws to
the side of the lathe bed and
place safely aside.
Locate the angle support casting and four
M8x35 caphead bolts and washers. Secure
the angle support to the side of the lathe
bed. DO NOT OVERTIGHTEN
35
Grub screws