Instruction manual

34
INITIAL ASSEMBLY - REMOVING THE SPLASH GUARD
1) Remove the four Phillip screws and pull out the electrical back plate to the rear of the lathe and lay the
circuit board to one side. (See fig 1 & 2 )
(NOTE. Be careful when lifting out the electrical circuit board as it contains delicate components)
2) Locate a 5mm allen key and 10mm spanner, remove the two caphead bolts and nuts that secures one side
of the splash guard to the headstock. ( See fig 3 & 4)
!
DISCONNECT THE LATHE FROM THE MAINS SUPPLY
Remove the four Phillip screws
and lift out the electrical panel
Electrical
back plate
Electrical
circuit
board
Headstock
Fig 2
Fig 3
Fig 4
Fig 1
Remove the two caphead bolts and nuts that secures one
side of the splash guard to the headstock
Two caphead bolts
Two 10mm nuts