Operating instructions

Additional Safety Instructions for Scroll Saw
6
event, switch OFF the machine and disconnect from
the supply. Wedge open the kerf, and withdraw the
work piece.
13. Switch off the saw, and make sure the blade has
come to a complete stop before clearing sawdust or
off-cuts from the table.
14. Make sure there are no nails or foreign objects in
the part of the work piece to be sawn.
15. Be extra cautious with very large or small, or
irregularly shaped work pieces.
16. Set up the machine and make all adjustments
with the power OFF, and disconnected from the
supply.
17. DO NOT operate the machine with the covers off.
They must all be in place and securely fastened when
performing any operation
18. Be sure to use the correct blade size and type.
19. Use ONLY approved replacement saw blades.
Contact your local Axminster Tool Centre for advice.
The use of inferior blades may increase the risk of
injury.
Code 508294
Model RSS16E
Rating Hobby
Power 100W 230V
Throat 406mm
Stroke 15mm
Cuts per Minute 400-1,600/min
Max Depth of Cut 50mm
Table Size 270 x 410mm
Table Tilt 0°-45° L & R
Dust Extraction Outlet 35mm
Overall L x W x H 600 x 270 x 400mm
Weight 14kg
Specification
Initial Assembly
Your scroll saw is fully assembled, except for the Blade
Guard assembly.
Locate the guard (B) and the two butterfly screw
knobs and flat washers (C). Place a flat washer over
the M5 threaded knobs, slot the guard over the
outside edges of the guard supporting arms and
offer up the two elongated holes with the threaded
Having unpacked your scroll saw and its accessories
please dispose of any unwanted packaging
properly. The cardboard packaging is biodegradable.
PLEASE DISPOSE OF ANY
UNWANTED PACKAGING
PROPERLY . THE POLYTHENE,
POLYSTYRENE AND CARD IS
RECYCLABLE .
Fig 01
holes in the arms. While holding the guard in place
introduce the two butterfly knobs (C) through the
guard assembly and into the supporting arms, lightly
tighten to lock the guard (B) in position, see figs
01-02-03
B
C