Specifications

Assembly
20
Step 10 Locate two ‘T’ bolts (d), fence spacers (c) and
at washers (i). Slide the ‘T’ bolts into the fence (K) ‘T’
slot and position the bolts roughly the width of the
extraction moulding (L) and place a fence spacer (c)
over the ‘T’ bolt thread. (See figs 51-52)
Figure 51-52
K
d
c
Step 11 Mount the dust shield (M) through the ‘T’
bolts (d), place a at washer (i) over the bolts and
secure using two locking knobs (b), see figs 53-54.
Fig 53
Fig 54
Fig 54
M
i
b
Mitre Fence Assembly
Step 1 Locate the mitre fence and extension (G),
Note: the bag of fixings will be tucked inside the
extension assembly. Slide the two Hex bolts into
the extension ‘T’ slot. Insert the Hex bolt down into
the machined slots in the mitre fence and secure
the assembly with the two wing nuts, DO NOT
OVERTIGHTEN! (See fig 55)
G
Mitre fence
extension
Hex bolt/washer
Wing nut
Step 2 Slide the mitre fence assembly (G) into the
tables ‘T’ slot, (see fig 55).
Fig 55