Specifications

Assembly
19
Fig 45
Q d
Step 7 Locate the two locking handle knobs (a) and
at washers (i). Line up the machined slots in the
fence (K) with the two locking Hex nuts (g) in the
fixing bracket (P). Place a washer (i) over the thread
on the locking handle knobs (a), screw the handle
knobs through the fence base clamping the fence
assembly to the table top. (See fig 46).
Fig 46
K
a
i
Machined slot
Step 8 Slide the fence assembly forward until
the front face lines up with engraved index line
embedded in the table, (see fig 47) clamp down
Fig 47
Engraved line
the fence assembly. Loosen the two locking knobs
beneath the fixing brackets (P), slide the two scales
until it reads (ZERO) to the front face of the fence
assembly, lightly tighten the locking knobs. (See figs
48-49)
Fig 48-49
Locking knob
Scale
Step 9 Locate the extraction moulding (L), Loosen
the two locking knobs (b) either side of the extraction
surround on the fence (K), slide the extraction
moulding (L) over the ‘T’ bolts (d) and retighten the
locking knobs (b). (See fig 50)
WARNING! DO NOT OVERTIGHTEN
THE LOCKING KNOBS AS THE
EXTRACTION MOULDING IS ONLY
PLASTIC!
Fig 50
L
b
Continues Over...