Specifications

Assembly
17
UJK Fence Assembly
Fig 33-34
Locking nut
Step 2 Insert a grub screw into each threaded corner
of the table insert, place a straight edge across the
table insert and using a Hex key adjust the grub
screws until the table insert is level with the table top.
(See fig 35)
Fig 35
Grub screw
Hex key
Straight edge
Step 3 Insert the two countersink Hex screws down
into the countersink holes in the table inset to lock
the insert in position. (See fig 36)
Fig 36
Countersink Hex screw
Step 1 Locate the fence fixing brackets (O) and the
eight Hex bolts (f). Line up one of the brackets with
the pre-drilled holes beneath the edge of the table
and secure in place with four Hex bolt (f), see figs 37-
38. Repeat for opposite side.
Fig 37-38
f
O
Continues Over...
Step 2 Insert three (1/4") square nuts (h) into the
machined slot to each fixing bracket (O), see fig 39.
Locate the two fence fixing brackets (P), M6 Hex
screws (e) and at washers (j), line up the machined
slots in the bracket (P) with the square nuts (h) and