Specifications

Assembly
14
Adjust the foot (4) until it’s level with the top of the
wheel (a), see image below. Repeat for the other side.
4
Step 12 Turn the stand upright, place a level on top
of the stand and adjust the nuts on the front feet
(4) until the stand is level and the mobility wheel
operates correctly, see fig 18.
a
Fig 18
4
Adjustable nut
Step 13 Locate the two cutter holders (F) and four
M6 bolts and washers (1-2). Line up the pre-drilled
holes in the cutter holder with the threaded holes to
ends of the upright supports (A), secure using two M6
bolts and washer, see fig 19. Repeat for the opposite
side, see fig 20.
Fig 19
Fig 20
Step 14 Locate the mitre fence tool rest (K), see fig
21, remove the two Phillips screws from the tool rest
and place safely aside. From the front of the stand
position the tool rest over the left upright support
column (A), above the cutter holder (F). Replace the
Phillips screws and tighten. (See fig 22)
The tool rest (K) can be reposition to face inside the
stand, see fig 23.
Fig 21
Fig 22
Phillips screws
F
K
A
K
F
1 2
Cutter Holder Assembly
Mitre Fence Tool Rest Assembly