Specifications

Assembly
13
Fig 13
Secure the end of the back plate to the lower support
bracket (E) and then turn the stand upright.
E
Rear Wheel Assembly
Step 10 Locate the wheel brackets (b), the four M6
Hex bolt (c) and M6 washers (e). Lineup the wheel
bracket (b) holes with the threaded holes to the base
of the upright support (A) and secure using two Hex
bolts and washers (c and e). (See fig 14) Repeat for
the opposite side. (See fig 15)
Step 11 Turn over the stand, locate the wheels (a),
M8x50 bolts (d), M8 washers (f ) and M8 nuts (g).
Position the wheel into the wheel bracket (b), insert
a M8 washer two either side of the wheel and line up
the holes. Insert the M8 bolt (d) through the wheel
bracket and secure using a M8 nut (g). (See figs 16-17)
Fig 14
Fig 15
b
c e
DO NOT OVERTIGHTEN!
otherwise the wheel will
not rotate freely.
Fig 16-17
d
f
b
a
Repeat for the other side see image below.
Continues Over...