Specifications

Assembly
12
Step 7 Locate the wheel support bracket (H), lineup
holes in the bracket with the threaded holes to the
base of the upright supports (A) and secure using
four M8 bolts and washers (1-2). (See fig 07-08)
Fig 07-08
Fig 09-10
H
1 2
4
Step 8 Locate the four adjustable feet (4), turn over
the stand assembly and screw each foot into the
base of the upright supports, see figs 09-10.
(Leave loose for adjustment later)
Step 9 Locate the mobility wheel assembly (J),
remove the five Hex bolt and washers and place
safely aside. Separate the back plate from the main
assembly, place the back plate inside the support
bracket (H) and line up the holes.
Offer up wheel assembly to the front of the support
bracket (H), lining up the holes, secure using the Hex
bolts you removed earlier. (See figs 11- 13)
Fig 11-12
J
Hex bolt/washers
Wheel assembly
Back plate
H
Mobility Wheel Assembly