Specifications

Assembly
11
UJK Router Table Leg Stand Assembly
Step 1 Locate the bag of bolts (M6x12mm) (1), at
washers M6 (2), upright supports (A) and the upper
side panels (long) (B). Secure one of the side panels
(B) to the top of the upright supports (A) with the M6
bolts and washers. (lightly tight) (See fig 1)
Step 2 Locate one of the lower support brackets
(long) (D) and secure to the upper supports (A) as
shown in fig 02. Repeat for the opposite side.
Step 3 Locate the upper side panels (short) (C)
and lower support brackets (short) (E). Secure the
lower support brackets (E) to the two front panels
you already assembled and lightly tighten. (See figs
03-04)
Step 4 Secure the upper side panels (C) to the front
panels and lightly tighten. (See fig 05) Now go round
the stand and tighten all the M6 bolts, see fig 06)
Fig 01
1 2
B
A
Fig 02
1 2
D
Fig 03-04
E
E
Fig 05
Fig 06
C
C
D
Continues Over...