Specifications

Operating Instructions
24
The NVR switch main function is the remote
switching of power tools such as routers when
mounted in a table (Max wattage 2000W).
The plug-in NVR switch offers a very convenient
solution; fit the switch in a convenient position on the
table, plug the tool into the switch and then plug the
lead on the switch into the mains supply and away
you go. You will need to devise a way of holding the
machine switch in the on position so that it is
over-ridden by the NVR; such as cable ties or plastic
tape.
Using the optional NVR Switch
BEFORE TURNING ON THE SWITCH
ON YOUR ROUTER MAKE SURE THE
SWITCH ON THE SWITCH BOX IS IN
THE OFF POSITION AND THAT THE
SWITCH BOX IS NOT YET CONNECTED
TO A POWER SOCKET.
BEFORE ROUTING CONNECT THE
MACHINE TO A DUST EXTRACTION
SYSTEM. ALWAYS TURN ON THE
DUST EXTRACTOR BEFORE STARTING
THE ROUTER AND ALWAYS STOP THE
ROUTER BEFORE TURNING OFF THE
DUST EXTRACTOR.
MAKE SURE TO READ, AND FOLLOW
ALL OPERATING INSTRUCTIONS AND
SAFETY GUIDELINES THAT CAME
WITH YOUR ROUTER FAILURE TO DO
SO MAY LEAD TO SERIOUS INJURY
AND/OR DAMAGE TO THE ROUTER,
TABLE, OR WORK PIECE.
There are two mounting brackets either side of the
switch with slots to secure the assembly to the router
table. Decide were you are going to mount the switch
then drill two holes in the table or use the pre-drilled
holes in the stand, using self tapping screws or two
bolts, washers and nuts. Secure the switch to the
stand (See fig A).
Fig A
Emergency stop button In an emergency “Slap” down
cover to stop the machine.
There is a 62mm dust outlet on the rear of the fence
assembly allowing for the connection of a dust
extractor (not included).
Be sure to use an appropriate size hose and fittings
and check that all connections are sealed tightly to
minimize airborne dust.
If you do not already own a dust extraction system,
consider contacting Axminster Tool Centre on 03332
406406 for information on our complete line of dust
extraction systems or visit our website at axminster.
co.uk.
• Install the required bit in your router according to
the instructions supplied with your router.
• Make sure that the router is rmly attached to the
table insert and that the plate is properly fitted and
level in the table opening.
• The router table should be installed on a at, sturdy,
and stable surface.
• When jointing, groove cutting, and/or prole cutting
always perform a test cut on a scrap piece of wood
before cutting your final piece.
Mounting bracket
On/Off Switch
‘I’ indicates On
‘O’ indicates Off
Connecting a Dust Extractor