Specifications

Assembly
16
Fig 28-29
Step 2 Insert three (1/4”) square nuts (h) into the
machined slot to each fixing bracket (L), see fig 30.
Locate the two fence fixing brackets (K), M6 Hex
screws (e) and flat washers (j), line up the machined
slots in the bracket (K) with the square nuts (h) and
secure both brackets with the M6 Hex screws (e), see
fig 31. DO NOT OVERTIGHTEN
UJK Fence Assembly
Step 1 Locate the fence fixing brackets (L) and the six
Hex screws flat and spring washers (f). Line up one of
the brackets with the pre-drilled holes beneath the
edge of the table and secure in place with four Hex
screws (f), see figs 28-29. Repeat for opposite side.
Pre-drilled holes
L
f
Fig 30
h
Fig 31
K
e
j
Step 3 Loosen the two locking knobs beneath the
fixing brackets (K), slide the two scales into the top
of fixing brackets recess and lightly tighten the
knobs, see fig 32.
Fig 32
Fig 33
Scale
Locking knob
K
Step 4 Locate the two lock Hex nuts (g) and slide
each one into the machined recess in the fixing
brackets (K), see fig 33.
g