Specifications

Assembly
15
Continues Over...
The following instructions are for the optional
UJK 6mm Aluminium table insert but it will apply
for the other options as well.
Step 1 Locate the table insert, four grub screws
and the two countersink Hex screws. Place the UJK
table insert into the tables recess, adjust the ten
countersink Phillips screws beneath the table, see
fig 23 until the table insert is roughly level with the
table surface. Adjust the locking nuts to lock the
countersink screws in position. (See figs 24-25)
Fig 23
Fig 24-25
Locking nut
Step 2 Insert a grub screw into each threaded corner
of the table insert, place a straight edge across the
table insert and using a Hex key adjust the grub
screws until the table insert is level with the table top.
(See fig 26)
Fig 26
Grub screw
Hex key
Straight edge
Step 3 Insert the two countersink Hex screws down
into the countersink holes in the table inset to lock
the insert in position. (See fig 27)
Fig 27
Countersink Hex screw