Specifications

Assembly
12
Step 6 Turn the stand over, locate the tool bracket
(2) and M6 fixing 6-7-8. Insert the coach bolt (6)
through the centre hole in the tool bracket (2) and
Step 7 Turn the frame over, locate the mitre fence
bracket holder and two Phillips screws/washers (1).
Lineup the holes in the bracket with threaded holes
Fig 06-07
Fig 08
Fig 12
Step 5 Locate the four rubber feet (3), (M6x20mm)
Phillips screws (4), flat washers (7) and M6 nuts (8),
see fig 6. Turn the stand over, place a rubber foot on
top of the leg support bracket (A)and line up the
pre-drilled holes. Place a flat washer (7) over the
Phillips screw (4) and insert the screw into the foot’s
recess, secure in place with the nut (8), (See fig 6-7).
Repeate the process for the remaining feet, see fig 8.
3 4 7 8
Fig 09-10-11
into the pre-drilled hole in the centre panel (F), angle
the bracket and secure using fixing (7-8), (See figs
9-10-11)
76
2
8
F
in the centre panel (F) and secure in place with the
Phillips screw. (See fig 12).
Step 8 Locate the two (M4) Phillips screws and nuts
(5-9), place a nut onto the Phillips screws an screw
1
Phillips screws