Specifications

Assembly
11
UJK Router Table Stand Assembly
Step 1 Locate the bag containing the coach bolts
(M6x12mm) (6), M6 flat washers and nuts (7-8), leg
support brackets (A) and side upper/lower panels
(D-E). Offer up the pre-drilled holes in the leg
supports with the holes in the upper/lower panels
as shown in fig 1 and secure using the M6 nuts bolts
washers. DO NOT OVERTIGHTEN. Repeat for the
remaining legs (A) and panels (D-E).
Fig 01
6 7 8
E
A
D
Fig 02
F
A
a
Continues Over...
Step 2 Locate the side centre panel (F) and one of
the stand sides, offer up the holes in the centre panel
with holes in the centre of the leg supports (A) and
secure with M6 fixings (6-7-8), (See fig 2)
Step 3 Find the rear extractor panel (G) and front
lower panel (C). Lightly tighten both panels to the
stand side as show in fig 3, using the M6 fixings.
Attach the remaining stand side to the other end,
(See fig 4).
Step 4 Locate the front and back upper panels (B)
and attach it to the frame work as shown in fig 5,
then go round and tighten all the fixing.
Fig 03
C
G
Fig 04
Stand side panels
Fig 05
B
NOTE Leave fixing hole (a) clear
to mount the tool bracket (2)
later in the assembly.