Specifications

Install the dust port
Install dust hoses
Place the dust port onto the bottom of rear panel,
tighten it with 4 M6x12 pan head screws washers and 1. Install the 2” dust hose onto the blade guard with 2”
nuts (nuts inside stand). hose clamp.
2. Put the 2” dust hose onto dust hose support, keep
free with the working table.
3. Another end of 2” dust hose clamps to the main dust
port on the bottom of rear panel.
4. Install 4” dust hose to main dust port with 4” hose
clamp
Install the blade guard
The riving knife cuts 3 slot for different blade size.
For PS10 the blade guard mounts to the 254 slot.
For PS12, if using the 254 mm blade place the blade
guard onto 254 slot; if using the 305 or 315 mm place
the blade onto 315 slot.
Install the dust hose support
To install the dust hose support onto the rear portion of
steel plate extension table with 2 M6x20 hex head
screws washers and nuts( nuts under the table).
12
Fig 19
Fig 23
Fig 22
Fig 21
Fig 20
Fig 24