User manual

BEFORE CUTTING
Loosen the lock plate (A) in Fig 1 to
release this saw. After service, must
replace the lock plate, and fasten it
properly for your safety and carry.
Failure to comply with the warning
could result in personal injury and
machine damage.
2.The Quick Vise And Work
Set Up
USAGE OF THE QUICK VISE
Novel and improved “quick action” vise has
been mounted on the machine. Three pieces
of devices & one handle simply solve all the
troubles you have met in the past. Follow the
easy steps as below. You’ll thank for the
design we made for your convenience.
1. Lift up the handle (A) in Fig. 2 then you
can move the vise forward and backward
with ease by holding the wheel (B) at the
left end of base.
2. Push the vise jaw (C) toward the work,
make it as close as possible against the
other vise jaw which is fixed.
3. Replace handle by pressing it down.
4. Turn the wheel (B) clock-wise to make
sure the work is well located. During
operation, you shall find it more
convenient & more powerful to fulfill the
clamp job than any of traditional ones
could offer.
Fig. 1
CAUTION !
NEVER OPERATE SAW WITHOUT
BLADE GUARDS IN PLACE
WORK SET UP
1. Raise saw head to vertical position.
2. Open vise to accept the piece to be cut
by pulling the wheel at the end of the
base.
3. Place work piece on saw bed if the piece
is long, support the end.
Fig. 2