User manual

08
WHITE
AXMINSTER
W
Initial Assembly Instructions Continued...
www.axminster.co.uk
Assemble the Depth (4) collar and ring (3) onto the column firmly.
(Fig 2)
Insert the Star Knob (2) complete with the two clamp bushes (21, 22) into the headstock
location.
Make sure the two cut outs are lined up towards the rear so as to allow the column to slide
past them.
Slide the headstock onto the column (6), you can see down the hole to make sure the
clamp cut outs mentioned above are clear of the column. When the column is completely
through the headstock casting you can tighten the Star Knob to clamp the headstock into
position.
Clean the spindle of any grease or oil and push the drill chuck (10) onto the spindle firmly.
Turn the chuck to make sure it is tight.
Put the handle (5) into the handle socket (7) and tighten with the wrench provided.
(Fig 1)
Specification
Axminster No.
200021
Max Drilling Capacity. 6mm (1/4”)
Spindle Travel 40mm (1.1/2”)
Headstock Travel 200mm (8”)
Spindle Taper B10
Speed Range Low range 0-3600 rpm
High range 0-5000 rpm
Base size 275mm X 165mm
Column size 30mm X 390mm
Motor power 150 W DC
Weight 14 KG