User manual

Removing the Chuck Assembly
18
Lower the quill to its maximum depth by turning the
feed lever handle. While holding the handle adjust
the depth stop nuts (A) to lock the quill in position,
(See fig 33)
Place a piece of timber on the drill table to prevent
the chuck from being damaged and lower the quill to
its maximum depth by turning the feed lever handle.
Fig 33
Preparation
You wil require the morse taper drift (11)
Fig 34
Removing the chuck
Morse taper arbor
Quill slot
Fig 35
While holding the handle in place turn the chuck to
line up the morse taper arbor in the quill’s machined
slot, (See fig 34). Insert the morse taper drift (11) in
the quill’s slot, thus pushing the morse taper down
and releasing the chuck, (See fig 35).
Morse taper drift
15
A