User manual

Assembly

Fig 17

caphead bolt, note the raised boss of the feed

mechanism and the two spigots inside the feed

handle. Mount the handle over the boss and ensure

the spigots inside the handle (7) engages into the

machined slot in the boss. Secure with the supplied

caphead bolt through the hole in the centre of the

handle through to the tapped hole in the mounting

boss (see ﬁgs 18-19-20-21).

Fig 18-19-20-21

Pulley cover knob

Locate the pulley cover knob (11), remove the Phillips

screw, insert the screw through the pre-drilled hole

in the pulley cover and secure the knob in place, see

ﬁg 22.

Fig 21

Continues Over...

Grub screw

Spigots

Raised bossThreaded hole

Machined slot