Instruction manual

Changing the Saw Blade

1. Locate the two screws as indecated holding the front of the saw guard bracket, and loosen and remove

them to allow the saw guard bracket to pivot on the rear screw. (See fig Q) Swing the saw guard bracket

and the guard fully out of the way, to enable access to the saw arbor bolt. (See fig R) Engage the saw arbor

lock and fit a 13mm spanner onto the bolt, keeping the lock depressed, loosen the saw arbor bolt by turning

clockwise, (left hand thread), (See figs S & Sa) once the bolt is free, unscrew, and remove the bolt, the

washer and the outer flange. Keeping the guard out of the way, tilt the blade off the inner flange and

‘wriggle’ it out of the saw. Watch out for sharp edges/teeth etc. Note. It sometimes helps to ‘wheel’ the

blade out of the guarding.

DISCONNECT THE SAW FROM THE MAINS SUPPLY

Screw 1

Screw 2

Fig Q

Fig R

Saw guard bracket

Saw guard

Swing the saw guard bracket and the guard fully

out of the way, to enable access to the saw arbor

bolt.

Arbor bolt

Flange

Rear screw