Instruction manual

Extension Arm/Cut Length Stop

Locate the two ‘U’ clamps, extention arms

and the

cut length stop assembly. Slide the cut length stop onto

the right extension arm. (See Fig D1) Introduce the two extention arms into their appropriate housings in

each side of the machine, slide the ‘U’ clamp onto the rear arm immediately inside the chassis frame, push

the arm forward until it engages in the second housing, secure the ‘U’ clamp and locking bolt on the arm,

tight against the inside of the chassis frame (or in such a position that the arm

cannot pull out of the second housing.) When you are happy that everything is

correctly positioned, tighten the locknut on the ‘U’ clamp bolt. (See fig D2)

Having unpacked your saw and its accessories please dispose

of any unwanted packaging properly. The packaging is biodegradable.

Initial Set Up

Lift the saw clear of the box using the two hand grips

moulded into the sides of the chassis, and set on a

clear flat surface, taking care not to trap or pinch the

power cable under the chassis. Remove the other

items from the box. Locate the five rubber feet and

insert them into each of the five machined holes

beneath the chassis. (See fig A)

Attach the sawdust collection bag to the dust extraction

duct to the rear of the operating handle. (See figs

A1,B2,C3)

Extension arm

Fig A1 Fig B2 Fig C3

Dust

extraction

duct

Phillips screw

Sawdust

collecting

bag

Rubber foot

Fig D1

Fig D2

Cut length stop

holes

‘U’ clamp

Locking bolt

Fig A