Specifications

Assembly Instructions
7
Attaching the Optional Extension Bed (951249)
Figure 05
Step 1: Remove the carrying handle from the
end of lathe bed and place safely aside
Figure 07
Figure 06
Step 2: Line-up the pre-drilled holes in the
extension bed (H) with the holes in the lathe
Figure 08
I
Step 3: Locate the two
5
/16 unc x 1” caphead bolts and spring/washers (I), Slot them through the holes in the
extension bed (H) & lightly screw them into the lathe bed, using a Hex key. Clamp the tailstock over
the two beds and adjust until both beds are aligned then tighten the bolts, (DO NOT OVERTIGHTEN).
(See figures 7-8) Replace the carrying handle (E) and screws to the end of the extension bed (H).
AT1416VS Lathe Extension Bed
H